Audiokaapeli XLR 3-pin 2 x XLR 3-pin musta Omnitronic 30225206

The Omnitronic 30225206 Audio Cable XLR 3-pin 2 x XLR 3-pin Black is a 3 m interconnection cable designed for reliable analogue audio signal transmission. One end terminates in a female XLR 3-pin connector and the opposite end splits to two male XLR 3-pin connectors, enabling connection of a single balanced source to two destinations or direct microphone-to-mixer wiring. Constructed in black with a robust outer jacket and solid connector housings, the cable is intended for studio and live-use environments where consistent signal quality and mechanical durability are required.

Advantages

This Omnitronic cable provides balanced XLR connectivity that reduces interference and preserves audio fidelity over the 3 m run. Durable connector shells and strain relief reduce mechanical wear at termination points, while the split 1-to-2 XLR configuration offers straightforward routing options without additional adapters. The cable's weight and flexible jacket make it manageable for stage setups and rack installations.

Suitable for

Key specifications

How to use

Connect the female XLR end to the microphone or audio source output and route the two male XLR ends to the desired inputs on a mixer, audio interface, or outboard device. Ensure connectors are fully seated and, where applicable, that channel gain and impedance settings match the source and destination equipment. Coil excess cable to avoid strain on connectors and to reduce the risk of tripping or accidental disconnection during use.

Recommendations

For optimal performance, avoid running the cable parallel to power cables to reduce hum and electromagnetic interference. Inspect connectors periodically for wear and clean contacts if connectivity issues occur. Use the 3 m length where short, direct runs are needed; for longer distances, consider a cable specifically rated for extended runs to maintain signal integrity.