BlueOptics UDC-1-BL InfiniBand-kuitu-kaapeli 1 m SFP+ musta

The BlueOptics UDC-1-BL InfiniBand fibre optic cable 1 m SFP+ Black is a 1-metre multimode fibre assembly with SFP+ connectors on both ends. Designed for high-speed interconnects in racks and data centre environments, the cable provides a compact, black-jacketed link that minimises signal loss over short to medium distances and is intended for use where SFP+ transceivers are required. The cable is presented as a durable, manufacturer-branded solution suitable for structured cabling and equipment-to-equipment connections.

Advantages

The cable supports SFP+ form-factor interfaces and is built to deliver consistent optical signal transmission with low attenuation across the 1 m length. Its black outer jacket offers discreet routing in rack installations and protection against mechanical wear. Because the product is intended for InfiniBand and similar high-speed protocols, it is suitable for maintaining bandwidth and signal integrity in dense networking and storage environments.

Suitable for

• Connecting SFP+ ports on switches, servers and storage appliances
• High-speed InfiniBand links within racks and between adjacent racks
• Data centre patching and short-reach optical interconnects

Key specifications

• Connector type: SFP+ on both ends
• Cable length: 1 metre
• Intended protocol support: InfiniBand and SFP+-based high-speed links
• Cable jacket colour: Black

How to use

Install the cable by inserting each SFP+ connector into the corresponding SFP+ port on your network device until it seats securely. Ensure devices are powered down or follow hot-plugging procedures recommended by the hardware vendor when inserting or removing SFP+ modules. Route the cable to avoid sharp bends and mechanical stress; maintain the specified minimum bend radius for optical assemblies. Verify link status and negotiated speed in your equipment management interface after connection.

Recommendations

For reliable operation, use the BlueOptics UDC-1-BL within its specified 1 m run length and pair it with compatible SFP+ ports and transceivers that support InfiniBand or other SFP+-based protocols. Avoid excessive tension, tight bend radii and exposure to liquids or extreme temperatures to preserve optical performance.