Aktiivinen optinen kaapeli CBO Alcatel-Lucent SFP-AOC-10G-5M 10Gbps 5 m

BlueOptics Active Optical Cable CBO compatible with Alcatel‑Lucent SFP-AOC-10G-5M delivers a 10Gbps full-duplex connection across a 5-metre optical link. Designed for short-range, high-speed interconnects, this SFP+ form-factor AOC replaces copper DACs to reduce electromagnetic interference and improve signal integrity between switches, servers and storage systems. The cable uses integrated optical transceivers to provide a compact, low-power solution for data centre and rack-level links.

Advantages

The Active Optical Cable offers 10Gbps bandwidth over a 5 m reach while maintaining low latency and reduced crosstalk compared with copper alternatives. Its SFP+ compatible connectors provide plug-and-play installation in standard SFP+ ports and eliminate the need for separate transceiver modules. The optical medium reduces susceptibility to electrical noise and allows for lighter, more flexible cable routing in dense rack environments. Power consumption is lower than many modular transceiver-plus-copper-cable combinations.

Suitable for

• Top-of-rack and end-of-row switch-to-switch connections
• Server-to-switch links within data centre racks
• High-speed storage area network (SAN) interconnects
• Low-latency links in clustered computing environments

Key specifications

• Nominal data rate: 10 Gbps (full duplex)
• Link length: 5 metres optical cable
• Form factor: SFP+ integrated active optical cable
• Transmission medium: multimode/mode-appropriate optical fiber with integrated transceivers
• Interface: SFP+ plug-and-play connectors on both ends
• Typical use: short-reach data centre and rack-level interconnects
• Benefits: low latency, reduced EMI susceptibility, flexible cable management

How to use

Insert each SFP+ connector into the corresponding SFP+ port on the networking devices until the latch engages. Ensure both devices are powered and that the port configuration supports a 10Gbps SFP+ link. No additional transceiver modules or patch cables are required. Verify link status LEDs or device diagnostics to confirm the connection is active and operating at the expected speed. For best results, route the cable following standard rack cabling practices and avoid tight bends near the connectors.

Recommendations

Use the cable for short-reach, high-bandwidth connections inside racks and between adjacent racks. Avoid installing the cable in environments with extreme mechanical stress or where the bending radius might be exceeded. Confirm compatibility with the switch or server vendor’s supported SFP+ AOC list when strict firmware or vendor validation is required.