BlueOptics MXK-10GE-SFP+-20KM-1310-BO kuituoptinen lähetin-vastaanotin SFP+ 10 km

The BlueOptics MXK-10GE-SFP+-20KM-1310-BO is a 10 Gigabit SFP+ fiber optic transceiver module designed for single-mode optical links with a maximum transfer distance of 10,000 meters. Housed in aluminium and weighing approximately 20 g, this SFP+ module uses a 1310 nm transmitter and receiver and fits standard LC duplex connectors. It supports 10 Gigabit Ethernet applications and is intended for integration into networking hardware that accepts SFP+ modules.

Advantages

The module provides high-speed 10 Gigabit Ethernet connectivity over single-mode fiber with a reach suitable for campus and metro links. Its aluminium housing offers physical robustness and thermal dissipation while the compact SFP+ form factor enables dense port installations. Built to MSA-design specifications, the transceiver supports simultaneous transmit and receive via an LC duplex interface and is compatible with typical network monitoring features when the host device supports Digital Diagnostic Monitoring (DDM/DOM).

Suitable for

Key specifications

How to use

Install the BlueOptics SFP+ module into a compatible SFP+ slot on your switch, router or host device while the device is powered on or according to the host vendor's hot-plug procedure. Connect LC duplex single-mode fiber patch cables between transceivers. Configure the host interface for 10 Gigabit operation if required by your device. If available and required, enable and monitor Digital Diagnostic Monitoring (DDM/DOM) through the host hardware to access real-time parameters such as supply voltage, laser bias current, optical output and input power, and module temperature.

Recommendations

For optimal performance, use single-mode LC duplex patch cords and maintain clean connector endfaces. Verify host device compatibility with 10GBASE-LR SFP+ modules and ensure firmware or driver settings permit third-party transceivers if necessary. Keep operating environment within the host vendor's specified temperature and humidity ranges and avoid bending or stressing fiber cabling beyond recommended bend radii.