BlueOptics QSFP-AOC-15M-NA-BO InfiniBand-kuitu-kaapeli 15 m uros/uros

The BlueOptics QSFP-AOC-15M-NA-BO InfiniBand fibre optic cable 15m Male/Male is a 15‑metre active optical cable designed for high‑speed, short‑reach interconnects in data centre and enterprise networking environments. Equipped with QSFP form‑factor connectors on both ends, this AOC provides a compact, low‑power alternative to separate transceivers and patch cords, enabling predictable latency and secure signal transmission over multimode fibre within racks and between adjacent racks.

Advantages

This QSFP active optical cable delivers consistent high bandwidth and reduced electromagnetic interference compared with copper alternatives. Its integrated optical transceivers eliminate the need for separate SFP/QSFP modules, simplifying installation and inventory. The 15 m length offers flexible placement for servers, switches and storage appliances while keeping signal integrity and low latency for InfiniBand environments. The plug‑and‑play design reduces setup time and the fixed‑length cable reduces clutter in dense rack deployments.

Suitable for

• Interconnects between QSFP‑equipped switches and routers within data centres
• High‑performance computing (HPC) clusters using InfiniBand fabric
• Connections between servers and storage arrays in rack environments
• Short‑reach aggregation links and low‑latency networking segments

Key specifications

• Connector type: QSFP male to QSFP male
• Cable type: Active Optical Cable (AOC) suitable for InfiniBand
• Length: 15 metres
• Use case: Short‑reach, high‑speed interconnects in racks and adjacent racks
• Signal medium: multimode optical link with integrated transceivers
• Latency: low‑latency design for high‑performance networking

How to use

Power down or follow hot‑swap procedures for your equipment if required by your hardware vendor. Insert each QSFP connector into the corresponding QSFP port until the latch engages. Verify link LEDs or management interfaces on switches and servers to confirm an active link. No external transceivers or patch panels are required; treat the cable as a single integrated interconnect. For moves or reconfiguration, disconnect by depressing the latch and pulling straight out to avoid damaging the connector.

Recommendations

Place the cable to avoid sharp bends and maintain the manufacturer’s minimum bend radius. Route the AOC to minimize stress on ports and avoid areas with heavy foot traffic or equipment that may pinch the cable. Ensure QSFP ports are compatible with InfiniBand and check firmware or driver requirements on network equipment for optimal performance.