BlueOptics SFP-10G-ZR-A-BO verkon lähetin-vastaanotinmoduuli kuitu 10000 Mbit/s SFP+

The BlueOptics SFP-10G-ZR-A-BO is a fiber optic SFP+ transceiver module designed for high-speed data transfer up to 10000 Mbit/s. Compact and lightweight with a silver housing and an SFP+ interface, it is intended for single-mode fiber links and conforms to common regulatory standards including CE, RoHS and FCC. The module supports LC duplex connections and is compatible with devices that accept SFP+ transceivers for 10G data transmission.

Advantages

The transceiver offers 10 Gbit/s line-rate capability in an SFP+ form factor, enabling integration into a wide range of network equipment. Its low weight (approximately 20 g) and compact dimensions make it easy to install and replace in switch and router ports. Compliance with CE, RoHS and FCC standards indicates adherence to regulatory, environmental and electromagnetic requirements. The optical LC duplex interface allows simultaneous transmit and receive operation over single-mode fiber for long-reach links.

Suitable for (tasks / use cases)

Key specifications

How to use

Insert the BlueOptics SFP-10G-ZR-A-BO module into a compatible SFP+ port on your switch, router or other network device while the host device is powered down or following the manufacturer's hot‑swap guidelines. Connect an LC duplex single‑mode patch cable to the module's connector for transmit and receive channels. Verify link status and configuration in the host device management interface; enable Digital Diagnostics Monitoring (DDM/DOM) if supported by your hardware to monitor parameters such as optical power and temperature.

Recommendations

Use single‑mode LC duplex fiber and matched patch cords for optimal range and signal quality. Confirm that the host hardware supports SFP+ transceivers and, if required, enable any vendor compatibility settings. Handle the transceiver by its housing, avoid touching the optical ferrule, and keep dust caps in place when the module is not connected.