SFP-kuitulähetin-vastaanotin CBO SFP-1G-EX yhteensopiva malli SFP-1G-EX-CP-BO

The SFP fiber optic transceiver CBO SFP-1G-EX compatible model SFP-1G-EX-CP-BO is a hot-pluggable small form-factor pluggable module designed to provide 1 Gbps fiber connectivity for network devices that accept SFP modules. Manufactured as a compatible replacement under the BlueOptics brand, this transceiver is intended for use in switches, routers and media converters to extend network links over optical fiber and enable interoperability with equipment that supports SFP form factor modules.

Advantages

This transceiver supports 1 Gbps data rates and is hot-pluggable, allowing installation or replacement without powering down the host device. As a compatible BlueOptics module, it is designed to match the physical SFP footprint and electrical interface expected by standard SFP ports. Its optical interface enables longer-distance links compared with copper ports and is suitable for installations where optical fiber is preferable for reduced electromagnetic interference and higher link stability.

Suitable for

• Extending network connections between switches, routers and media converters over optical fiber
• Replacing failed or missing SFP modules in devices that support 1 Gbps SFP transceivers
• Deployments requiring hot-swappable fiber interfaces for flexible maintenance

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Nominal data rate: 1 Gbps
• Optical interface: fiber optic transceiver suitable for standard SFP fiber ports
• Compatibility: designed as a compatible BlueOptics module for devices accepting SFP form-factor transceivers
• Hot-pluggable: yes

How to use

Insert the transceiver into an available SFP slot on a switch, router or media converter until it seats securely. Connect the appropriate single-mode or multimode optical fiber cable to the transceiver’s port using the correct connector type for your cabling (confirm connector type and fiber type on your device). The host device should automatically recognise the module and negotiate link parameters at 1 Gbps with the remote endpoint. To remove the transceiver, follow the host device’s hot-swap procedure and carefully extract the module by the housing.

Recommendations

Verify the fiber type, connector type and link budget required by your network before installation. Use dust caps when the transceiver is not connected and avoid excessive bending of fiber optic cables. If interoperability issues occur, check device compatibility lists or firmware requirements on the host device.