SFP+ lähetin-vastaanotinmoduuli CBO GP-10GSFP-1S-BO 10 Gbit/s 850 nm

The SFP+ Transceiver Module CBO GP-10GSFP-1S-BO 10 Gbit/s 850 nm is a compact hot-pluggable optical module designed for short-range 10 Gigabit Ethernet links over multimode fiber. It uses an 850 nm VCSEL light source to deliver reliable data transfer at 10 Gbit/s and is compatible with standard SFP+ ports. The module is intended for deployments where low-latency, high-throughput connections are required between switches, servers and storage area network (SAN) equipment.

Advantages

This SFP+ transceiver provides a cost-effective solution for short-distance 10 Gbit/s connectivity over multimode fiber. Its hot-pluggable form factor allows installation without powering down network equipment, and the standardized SFP+ interface ensures broad compatibility with switches and servers that accept SFP+ optics. The 850 nm wavelength supports common multimode fiber types and enables low-latency links suitable for data center and campus environments.

Suitable for

Key specifications

How to use

Insert the SFP+ transceiver into an empty SFP+ port on your switch, server or media converter until it clicks into place. Connect an LC duplex multimode fiber patch cable to the transceiver, ensuring correct transmit/receive orientation. After installing, verify link status via device LEDs or management interface and configure link speed and duplex settings as required. To remove the module, disengage any retention latches and gently extract the transceiver while the host device remains powered if hot-plug removal is supported.

Lietošanas ieteikumi

Use multimode fiber with appropriate modal bandwidth for short-range 10 Gbit/s operation, keep connectors and transceiver ports clean to maintain signal quality, and follow manufacturer guidelines for operating temperature and handling. Verify compatibility with your network equipment and firmware to ensure proper link negotiation and performance.