SFP28-kuitu-lähetin-vastaanotin CBO YP6HW 25 Gbps yksiporttimoduuli

The SFP28 fiber optic transceiver CBO YP6HW 25 Gbps single-port module is a hot-pluggable optical interface designed for 25 Gigabit Ethernet links. Manufactured for compatibility with BlueOptics systems and third-party switches and servers that accept SFP28 modules, this transceiver enables short- to medium-reach fiber connections for data center, enterprise and carrier networks. The module supports a single optical channel at 25 Gbps and is intended for uplink, aggregation and high-speed server connectivity where a compact pluggable form factor is required.

Advantages

This SFP28 module provides a compact, industry-standard pluggable solution for 25 Gbps fiber links. Its hot-pluggable design allows insertion and removal without powering down the host device, reducing maintenance windows. The module is built to meet typical optical transceiver environmental and performance expectations for reliable operation in data center and enterprise environments. Compatibility with common SFP28 ports simplifies deployment and replacement in existing infrastructures.

Suitable for

• 25 Gigabit Ethernet uplinks in data center racks
• Aggregation links between switches and routers
• High-speed server network interfaces
• Carrier access and metro connections within short to medium reach

Key specifications

• Interface: SFP28 small form-factor pluggable
• Data rate: 25 Gbps single optical channel
• Optical medium: single-mode or multi-mode fiber compatibility depending on transceiver variant
• Reach: suitable for short- to medium-range connections (link distance depends on fiber type and transceiver variant)
• Connector type: LC duplex (typical for SFP28 fiber modules)
• Power: low-power single-port module compatible with hot-swap operation

How to use

Install the SFP28 transceiver into an available SFP28 slot on a compatible switch, router or server until it clicks into place. Connect the appropriate LC-terminated fiber patch cable to the module, ensuring correct transmit/receive orientation. After insertion, verify link status and speed via the host device interface or management system. To remove, disconnect the fiber cable and press the module latch or release mechanism before pulling the transceiver out. Observe electrostatic discharge precautions and follow the host device manufacturer’s handling guidelines.

Recommendations

Use validated fiber cable types and maintain clean LC connectors to ensure optimal signal quality. Confirm compatibility with the host device and, if required, check firmware or vendor compatibility lists before deployment. Store unused modules in protective caps or packaging to prevent contamination.