BlueOptics SFP3132BU7.5MX InfiniBand-kuituoptinen kaapeli 7,5 m LC SC

The BlueOptics SFP3132BU7.5MX InfiniBand fibre optic cable 7.5 m LC SC is a duplex multimode/single-mode interconnect designed for high-speed data transmission in networking equipment and data center environments. The cable measures 7.5 metres and terminates with an LC connector on one end and an SC connector on the other, providing compatibility with a wide range of transceivers and patch panels. Constructed with G.657.A1 fibre type, the cable is optimized for minimal bend sensitivity and stable signal integrity over the specified link length.

Advantages

This InfiniBand fibre cable supports full duplex communication and is engineered for consistent throughput and low insertion loss, which helps maintain link performance in dense cabling racks. The use of G.657.A1 fibre reduces performance degradation in environments with tight bends or constrained cable routing. With LC and SC connectors, the cable provides flexible connectivity between different interface types without the need for additional adapters.

Suitable for

• High-speed server interconnects in data centres
• Inter-rack and intra-rack fibre patching
• Connecting InfiniBand switches, host channel adapters and transceivers
• Environments with limited bend radius or restricted cable paths

Key specifications

• Cable length: 7.5 m
• Connector types: LC to SC
• Fibre type: G.657.A1
• Transmission mode: full duplex
• Application: InfiniBand and high-speed networking
• Typical use: data centre and enterprise network cabling

How to use

Inspect both connector ends for contamination before insertion and ensure ports are powered down per equipment guidelines if required. Insert the LC connector into the corresponding LC port and the SC connector into the appropriate SC socket until a secure connection is achieved. Route the cable following recommended bend radius limits for G.657.A1 fibre to avoid microbending losses. Verify link status and perform any required optical power or BER measurements to confirm correct operation.

Recommendations

Handle connectors by the boot or connector housing and use dust caps when the cable is not connected. For permanent installations, secure the cable with appropriate clips or ties without applying excessive tension. Regularly clean connector endfaces with approved cleaning tools to maintain low insertion loss and high signal quality.