Bosch 2 608 644 110 pyörösahanterä

The Bosch 2 608 644 110 circular saw blade is a 216 mm diameter blade engineered for cutting aluminum with precision. Featuring a 30 mm bore, this single-piece blade is suitable for stationary and portable circular saws that accept a 30 mm arbor. The tooth geometry and cutting edge are optimized to reduce burrs and deliver smooth, accurate cuts in non-ferrous metals, while the solid construction supports consistent performance during repetitive cutting tasks.

Advantages

This circular saw blade provides clean cutting results on aluminum thanks to its tooth design and edge treatment, minimizing post-cut finishing. The 216 mm diameter balances cutting capacity and control, allowing efficient throughput while maintaining operator handling. The standardized 30 mm bore ensures compatibility with many saw models that accept this arbor size. Supplied as a single unit, the blade is easy to replace and store.

Suitable for

• Cutting aluminum sheet, profiles and extrusions
• Workshop and fabrication tasks involving non-ferrous metals
• Portable circular saws and table saws with a 30 mm arbor
• Precision trimming and panel cutting where smooth edges are required

Key specifications

• Diameter: 216 mm
• Bore (arbor) diameter: 30 mm
• Material compatibility: aluminum and other non-ferrous metals
• Package quantity: single blade

How to use

Install the blade on a compatible circular saw or table saw that accepts a 30 mm arbor, following the machine manufacturer's instructions for blade mounting and safety. Ensure the saw is powered off and disconnected from the power source before fitting the blade. Set appropriate cutting speed and feed rate for aluminum to avoid overheating and to reduce burr formation; use a lubricant or cutting fluid if recommended for the specific application. After cutting, inspect the workpiece for burrs and perform light deburring if necessary.

Recommendations

Use appropriate personal protective equipment, including eye and hearing protection. Match the blade to the saw's maximum RPM rating and keep the blade clean of sticky residues. For prolonged blade life and consistent results, avoid cutting ferrous materials or hardened alloys with this blade and store the blade in a dry place to prevent corrosion.