CBO AOC SFP28 BlueOptics BO272703Q2M aktiivinen optinen kaapeli, 2 m pituus

The CBO AOC SFP28 BlueOptics BO272703Q2M active optical cable, 2 m length, is a factory-terminated SFP28-to-SFP28 link designed for short-reach connections in data centers and enterprise networks. This active optical cable provides a low-latency, high-bandwidth alternative to copper DACs by integrating optical transceivers and multimode fiber within a single, compact assembly. The plug-and-play design eliminates the need for separate transceivers and simplifies equipment interconnects between switches, servers and storage devices with SFP28 ports.

Advantages

The AOC offers improved signal integrity and electrical isolation compared with passive copper cables, reducing susceptibility to electromagnetic interference. Its integrated optical components deliver consistent high-speed performance over the 2 m length while keeping ports free of dust during handling. The factory termination and standardized SFP28 connectors ensure straightforward installation and compatibility with equipment supporting standard SFP28 AOC connections, enabling lower power consumption and reduced heat generation at the link compared with some alternative solutions.

Suitable for

• Short-reach interconnects within racks or between adjacent racks in data centers
• Direct connections between SFP28-equipped switches and servers
• High-density deployments requiring compact, low-profile cabling
• Environments where electrical isolation and EMI resistance are important

Key specifications

• Form factor: SFP28 to SFP28 active optical cable
• Length: 2 meters
• Data rate: supports 25 Gbps per lane (SFP28 specification)
• Connector type: standardized SFP28 module housings
• Medium: integrated optical fiber with active transceiver electronics
• Latency: low-latency optical transmission suitable for server and switch interconnects

How to use

Install the cable by inserting each SFP28 end into the corresponding SFP28 port on the networking devices until the connector latches. No separate transceivers or fiber termination is required; the cable is factory-terminated and ready for plug-and-play operation. Verify link status through device LEDs or management interfaces after insertion and ensure proper port configuration on switches or servers to enable the desired 25 Gbps link. To remove, release the latch and pull the connector straight out to avoid stressing the cable assembly.

Recommendations

For reliable performance, route the cable to avoid tight bends and excessive mechanical stress; observe the manufacturer’s minimum bend radius. Use this AOC for short, fixed-length connections inside racks or between adjacent racks rather than long-distance runs. Keep SFP28 ports and connectors free of contaminants and handle the cable by the connector housings when inserting and removing.