Cudy SM220 SFP-T 10/100/1000Mbps RJ45 Ethernet-moduuli

Upgrading network infrastructure often hits a wall when legacy copper cabling meets modern fiber-optic switches. The Cudy SM220 SFP-T module bridges that gap, converting an SFP slot into a Gigabit RJ45 port so you can connect standard Cat5e/Cat6 cables directly to fiber switches, media converters, or routers. No need to rip out existing copper runs or buy new switches—just plug in this hot-swappable transceiver and extend your network up to 100 meters over twisted pair.

Who is it for

IT administrators, system integrators, and small-to-medium businesses that operate mixed copper and fiber networks. If you have a switch with empty SFP slots and need to link copper-based devices like IP cameras, access points, or workstations, this module delivers instant compatibility without costly hardware replacements.

Main features

• Converts an SFP slot to a 10/100/1000 Mbps RJ45 copper port
• Supports auto-negotiation for speed and duplex, ensuring seamless link establishment
• Hot-pluggable design allows insertion and removal without powering down the switch
• Digital Diagnostic Monitoring (DDM/DOM) provides real-time monitoring of temperature, voltage, and optical power
• MSA compliant for broad compatibility with Cisco, Ubiquiti, MikroTik, TP-Link, Netgear, D-Link, and other major brands
• Zinc alloy housing ensures durability and effective heat dissipation
• Low power consumption of less than 1.2 W reduces energy costs and thermal load

Specifications

• Module type: SFP (Small Form-Factor Pluggable)
• Data rate: 10/100/1000 Mbps (Gigabit Ethernet)
• Connector: RJ45
• Interface: SFP to Copper
• Max cable distance: 100 meters (328 feet)
• Compatible cable: Cat5e, Cat6, Cat6a, Cat7 UTP/STP
• Standards: IEEE 802.3ab (1000BASE-T), IEEE 802.3u (100BASE-TX), IEEE 802.3 (10BASE-T)
• Power consumption: <1.2 W
• Supply voltage: 3.3 V
• Operating temperature: 0°C to 70°C (32°F to 158°F)
• Storage temperature: -40°C to 85°C (-40°F to 185°F)
• Housing material: Zinc alloy

Tips

Before installation, verify that your switch or router supports SFP copper modules and auto-negotiation. For best performance, use Cat6 or higher cabling for Gigabit speeds over longer distances. The module is plug-and-play, but always check for firmware updates on your network equipment to ensure full DDM functionality.