Jatkoliitin ShiverPeaks BS72020-SET10 TAE N musta

The ShiverPeaks BS72020-SET10 Wire Connector is a TAE N male connector finished in black, supplied as a pack of 10 units. It is designed for creating secure, low-profile telecommunication and audio/data connections where a TAE N male interface is required. The connector's exterior and mechanical design focus on reliable mating, consistent contact pressure and straightforward installation for common wiring projects.

Advantages

The connector provides a compact form factor and a standardized TAE N male interface suited to compatible sockets. Its black finish offers a neutral appearance for visible installations, while the supplied quantity of ten units supports multiple terminations or small installation runs. Mechanical retention and contact design aim to reduce signal loss and ensure stable connections over repeated insertions.

Suitable for

• Telecommunication and telephone wiring requiring TAE N male plugs
• Audio or low-voltage data connections using TAE N interfaces
• Small installation projects and repair kits
• Prototyping and internal wiring where a compact male TAE connector is needed

Key specifications

• Connector type: TAE N male
• Finish: black
• Package quantity: 10 pieces
• Intended use: low-voltage telecommunication and data signals
• Mechanical design: retention contacts for repeated mating

How to use

Prepare the cable ends according to the conductor size appropriate for TAE contacts, strip insulation to the recommended length and insert conductors into the connector contacts following the wiring scheme of your device or socket. Ensure secure seating by pushing the connector fully into the mating TAE socket until it latches. For removal, press any release feature on the socket and withdraw the connector straight out to avoid bending contacts. Follow standard safety procedures: disconnect power where applicable and verify wiring continuity after installation.

Recommendations

Use the connectors in dry indoor environments and avoid exposure to excessive moisture or corrosive atmospheres. Select appropriate cable types and ensure correct conductor cross-section to maintain reliable contact pressure. For frequent plug cycles, periodically inspect contacts for wear and replace individual connectors if mechanical retention or contact continuity degrades.