Kuitulähetin-vastaanotin BlueOptics 407-BBOO 1250 Mbit/s SFP 1310 nm

The BlueOptics 407-BBOO 1250 Mbit/s SFP 1310 nm is a fiber optic transceiver module designed for standard SFP slots. It supports a maximum data transfer rate of 1250 Mbit/s and transmits at a wavelength of 1310 nm, providing compatibility with single-mode fiber links for short to medium distances. The module fits typical network equipment with SFP interfaces and is intended for straightforward installation and replacement in switches, routers and media converters.

Advantages

This BlueOptics SFP module offers a compact form factor compatible with common SFP ports and supports reliable optical transmission at 1310 nm. The module’s 1250 Mbit/s data rate meets the requirements for many legacy and industrial Ethernet links. Its design allows for hot-pluggable insertion into network devices, enabling fast replacement or upgrades without powering down equipment.

Suitable for

• Fiber uplinks between switches and routers using SFP ports
• Connections to media converters and optical line equipment
• Industrial and enterprise networks requiring single-mode fiber links
• Network maintenance and replacement of existing 1250 Mbit/s SFP modules

Key specifications

• Form factor: SFP (small form-factor pluggable)
• Data rate: up to 1250 Mbit/s
• Operating wavelength: 1310 nm
• Optical medium: single-mode fiber compatibility
• Hot-pluggable design for tool-free insertion and removal

How to use

Insert the BlueOptics 407-BBOO into an available SFP slot on a supported switch, router or media converter until it seats firmly. Connect a properly terminated single-mode fiber cable to the transceiver’s optical connector, observing correct connector type and polarity. After insertion and cable connection, verify link and activity LEDs on the host device and check network configuration to ensure the interface is enabled and set to the appropriate speed. To remove the module, follow the host equipment’s hot-swap procedure and pull the transceiver straight out to avoid connector damage.

Recommendations

Use factory-quality single-mode fiber with correct connector types and dust caps when the module is not connected. Verify that the host device supports SFP modules with a 1250 Mbit/s rate and 1310 nm wavelength. Avoid excessive bending of fiber cables near the transceiver and operate the module within the equipment manufacturer’s specified temperature and humidity ranges.