Kuitulähetin-vastaanotinmoduuli BlueOptics 10-2620-01-BO SFP+ 300 m

The BlueOptics 10-2620-01-BO SFP+ 300m is a fiber optic transceiver module designed for 10G data transmission over multimode fiber up to 300 metres. The module uses an SFP+ interface in an aluminium housing and weighs approximately 20 g, providing a compact, lightweight solution for high-speed network links. It implements 10GBASE-SR optical signalling with 850 nm wavelength and an LC duplex connector according to common MSA standards, supporting simultaneous transmit and receive channels for short-range 10 Gigabit Ethernet and similar protocols.

Advantages

The module provides high-speed 10G connectivity over multimode fiber with a maximum reach of 300 m, low weight and durable aluminium construction for easy insertion into SFP+ ports. It follows industry MSA specifications and is compatible with major networking platforms that accept 10GBASE-SR SFP+ modules. Digital diagnostic monitoring (DDM/DOM) support offers real-time optical and electrical parameters to simplify maintenance and troubleshooting.

Suitable for

• Short-range 10 Gigabit Ethernet links in data centres and enterprise networks
• Interconnections between switches, routers and storage systems within a building or campus
• High-speed Fibre Channel over Ethernet and other low-latency optical applications up to 300 m

Key specifications

• Interface: SFP+ form factor
• Optical standard: 10GBASE-SR (850 nm)
• Connector: LC duplex
• Maximum reach: up to 300 metres over multimode fiber
• Housing material: aluminium
• Weight: approximately 0.02 kg
• Supports digital diagnostic monitoring (DDM/DOM) compliant with MSA SFF-8472

How to use

Install the module into a compatible SFP+ port on supported network equipment ensuring the device accepts 10GBASE-SR transceivers. Connect LC duplex multimode fiber patch cords to the transceiver and to the corresponding port or patch panel. Verify link status on the host device and, if available, monitor optical and electrical parameters via the DDM/DOM interface to confirm proper operation. Follow vendor instructions for hot-plug handling and electrostatic discharge (ESD) precautions during installation.

Recommendations

For best performance, use OM3/OM4 multimode fiber and high-quality LC duplex patch cords, keep connector end-faces clean, and verify that the network equipment firmware supports third-party 10GBASE-SR SFP+ modules and DDM/DOM functions.