Kuitulähetin-vastaanotinmoduuli BlueOptics 943015001-BO 1250 Mbit/s LC

The BlueOptics 943015001-BO is a single‑mode SFP fiber optic transceiver module designed for 1.25 Gbit/s (1250 Mbit/s) links and equipped with an LC duplex interface. Housed in a compact SFP form factor and weighing approximately 20 g, the module supports optical transmission and reception at 1310 nm and is intended for use in networking equipment that supports MSA‑compliant SFP modules.

Advantages

The module offers MSA‑compatible SFP form factor interoperability, a small lightweight silver housing for easy installation, and a 1250 Mbit/s data rate suitable for Gigabit and related serial protocols. Constructed to work with standard LC duplex fiber connections, it supports single‑mode fiber runs over long distances and includes components selected to provide stable optical performance and long operational lifetime.

Suitable for

• Gigabit Ethernet uplinks and inter-switch connections
• Router and switch optical ports that accept SFP modules
• Storage area network links and fibre channel over Ethernet applications
• Long‑reach single‑mode fiber links where 1310 nm transmission is required

Key specifications

• Form factor: SFP (Small Form‑factor Pluggable)
• Interface: LC duplex connector
• Maximum data transfer rate: 1250 Mbit/s (1.25 Gbit/s)
• Optical wavelength (typical): 1310 nm transmit and receive
• Fiber type: single‑mode fiber (SMF)
• Product colour: silver
• Weight: approx. 0.02 kg

How to use

Install the BlueOptics 943015001-BO into a compatible SFP port until it latches, then connect LC duplex single‑mode fiber patch cords to the transmit and receive channels. Ensure the host hardware supports MSA‑compliant SFP transceivers and, if required, enable Digital Diagnostics Monitoring (DDM/DOM) in the device to read real‑time optical parameters. Configure the network interface on the host device for the desired protocol (for example Gigabit Ethernet or Fibre Channel over Ethernet) and verify link status and correct optical power levels after connection.

Recommendations

Use high‑quality single‑mode LC patch cords and, when possible, route fibers through patch panels to protect connectors. Verify compatibility with the target switch or router model and check that the firmware accepts third‑party SFP modules. If DDM/DOM monitoring is required, confirm the host supports those diagnostics to enable remote monitoring of supply voltage, laser bias current, optical transmit/receive power and module temperature.