Kuitulähetin-vastaanotinmoduuli BlueOptics FS-TRAN-GC-BO SFP 100 m alumiini

The BlueOptics FS-TRAN-GC-BO SFP is a fiber optic transceiver module engineered for short-reach, high-speed network links up to 100 meters. Housed in an aluminium casing and weighing approximately 20 grams, this SFP form-factor module is designed to fit standard SFP ports and provide dependable data transmission where compact size and mechanical durability are required. The module supports common networking environments and is compatible with devices that accept SFP transceivers following MSA guidelines.

Advantages

The aluminium housing offers a lightweight yet robust enclosure that aids heat dissipation and mechanical protection. With an SFP interface and a compact design, the transceiver is easy to install or replace in switches, routers and other network hardware. The module supports reliable data transfer over distances up to 100 m, making it suitable for short-range optical links where predictable performance and small form factor are priorities.

Suitable for

Key specifications

How to use

Power down or follow hot-swap procedures recommended by your network hardware vendor before inserting or removing the SFP module. Align the transceiver with the SFP slot and push it gently until it latches; for removal, release any retention mechanism and slide the module out. Connect the appropriate fiber patch cable or compatible connector to the module’s optical interface, ensure correct polarity, and verify link LEDs or management interfaces on the host device to confirm link establishment.

Recommendations

Use quality multimode fiber and properly rated patch cords for distances up to 100 m, and avoid sharp bends or excessive tensile stress on fiber cables. Verify that the host device supports third-party SFP modules and consult device firmware documentation if link negotiation issues arise.