KuitusFP-lähetin-vastaanotin BlueOptics F5-UPG-SFPC-R-BO 100m alumiini

The BlueOptics F5-UPG-SFPC-R-BO 100m Aluminium is a fiber optic SFP transceiver module designed for short-distance high-speed network links up to 100 meters. Housed in an aluminium enclosure and weighing approximately 20 grams, this single-pack SFP module follows MSA-compatible SFP form factor and is intended for insertion into SFP ports on switches, routers and other networking equipment that support 1 Gbps optical or copper SFP modules. The module provides a standardized SFP interface for straightforward integration into existing infrastructures and supports common diagnostic and monitoring functions when the host hardware provides Digital Diagnostic Monitoring (DDM/DOM) support.

Advantages

The aluminium housing offers mechanical protection and thermal dissipation in a compact 20 g module, suitable for dense installation environments. Compliance with SFP interface standards ensures broad device compatibility and plug-and-play operation in systems that accept equivalent 1 Gb SFP transceivers. The module is supplied as a single unit, simplifying stock and replacement management for small-scale deployments or targeted upgrades.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP transceiver into an empty SFP slot of a compatible network device while the device is powered down or following the vendor’s hot-plug instructions. Connect the appropriate fiber or copper patch cable matching the transceiver type and the device’s port. If the host supports Digital Diagnostic Monitoring (DDM/DOM), verify link and diagnostic parameters through the device management interface to confirm proper operation and signal quality. Follow your equipment manufacturer’s guidance for driver, firmware or compatibility considerations.

Recommendations

For optimal performance, use high-quality patch cords and ensure connectors and patch panels are clean and undamaged. Confirm that the target device officially supports equivalent SFP transceivers and that any DDM/DOM features required for monitoring are enabled on the host equipment.