Kupari-lähetin-vastaanotin-moduuli BlueOptics AA1403043-E6-AA 10000 Mbit/s SFP+

The BlueOptics AA1403043-E6-AA 10000 Mbit/s SFP+ copper transceiver module is a compact network interface designed for short-range, high-speed Ethernet connections. Housed in a silver metal enclosure and weighing approximately 20 g, this single-pack module supports up to 10 Gbit/s data transfer over copper cabling and fits standard SFP+ ports. It is intended for use in switches, routers and network interface cards that accept SFP+ copper modules and where reliable, low-latency connectivity is required.

Advantages

This SFP+ copper transceiver offers a high maximum data transfer rate of 10000 Mbit/s in a small form factor compatible with SFP+ ports. The metal silver housing provides mechanical robustness and helps with heat dissipation during operation. With a low weight and single-unit packaging, the module is easy to install, replace or carry as a spare part. The copper interface eliminates the need for fiber optics in short-distance links, simplifying cabling and reducing component costs where appropriate.

Suitable for

• 10 GBase-T connections between switches and servers over copper
• Upgrading SFP+ ports on network equipment to support 10 Gbit/s copper links
• Short-reach data center links and rack-to-rack connections
• Spare or replacement transceiver in managed and unmanaged network devices

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Form factor: SFP+ copper transceiver module
• Housing colour: Silver metal enclosure
• Weight: approximately 0.02 kg (20 g)
• Pack quantity: 1 unit

How to use

Power off or follow hot-swap procedures of the host device, then insert the transceiver into an available SFP+ slot until it clicks into place. Connect the appropriate copper cable to the module and ensure link/activity LEDs on the host device indicate an established connection. Configure port settings on the switch, router or network interface card as required for 10 Gbit/s operation and duplex settings. For removal, release the module latch or lever and gently pull the module straight out of the slot.

Recommendations

Use certified shielded copper cabling rated for 10 Gbit/s and keep cable lengths within the supported range for copper SFP+ links. Avoid excessive force when inserting or removing the module, and store unused modules in anti-static packaging to protect electronic components.