kwb 241136 SDS-Plus vasaraporanterä 6 x 110 mm

The kwb 241136 is a single SDS-Plus hammer drill bit with a 6 mm diameter and 110 mm total length, built for rotary hammer drilling in concrete, masonry, stone, and brick. Its tungsten carbide tip and optimized spiral flute set it apart from standard twist bits by delivering faster chip removal and higher wear resistance in abrasive materials.

Highlights

• SDS-Plus shank for secure, tool-free bit changes in rotary hammers
• Tungsten carbide tipped (TCT) cutting edge for long life in hard materials
• Centering tip for accurate hole starts without wandering
• Optimized spiral flute for efficient dust and debris evacuation
• Heat-treated steel body for added durability under hammering loads

In daily use

Designed for hammer drilling into concrete, masonry, stone, and brick, this bit delivers clean, precise holes with reduced walking. The 2-cutter head and SDS-Plus connection make it a practical choice for anchoring, rebar avoidance, and general installation work where speed and accuracy matter.

Full specifications

• Drill Bit Type: Hammer Drill Bit
• Shank Type: SDS-Plus
• Diameter: 6 mm
• Total Length: 110 mm
• Material: Tungsten Carbide Tipped (TCT)
• Number of Cutters: 2
• Tip Design: Centering Tip
• Flute Design: Optimized Spiral Flute
• Pack Quantity: 1 piece
• Drilling Method: Hammer Drilling

Final note

A reliable single-bit solution for professionals and serious DIYers who need consistent performance in concrete and masonry without frequent bit changes.