Microconnect UTP610R verkkokaapeli punainen 10 m Cat6 U/UTP (UTP)

The Microconnect UTP610R is a 10 m Cat6 U/UTP networking cable with RJ-45 connectors at both ends. It supports Cat6 performance up to 250 MHz and data transfer rates up to 10000 Mbit/s, and is backward compatible with Cat5e and Cat5 installations. The cable includes strain-relief boots (snaggles) to protect the connector during installation and is suitable for home, small office and entertainment network connections, patch panels, keystone jacks and wall outlets.

Advantages

The cable provides Cat6 performance tested to 250 MHz while remaining compatible with older Cat5e/Cat5 systems. Its 10 m length and standard RJ-45 connectors make it ready for immediate use in typical network setups. The included boots reduce the risk of damage when routing the cable in confined spaces. The red colour helps with visual identification in multi-cable environments.

Suitable for

• Connecting switch, modem or router to another network device
• Linking devices to patch panels, keystone jacks or wall outlets
• Home and small office wired networks
• Entertainment systems and media devices

Key specifications

• Cable length: 10 m
• Standard: Cat6, tested to 250 MHz
• Shielding: U/UTP (unshielded twisted pair)
• Connectors: RJ-45 to RJ-45
• Maximum data rate: up to 10000 Mbit/s
• Backward compatibility: Cat5e, Cat5
• Colour: Red
• Weight: 0.238 kg

How to use

Connect one RJ-45 connector to the network port of your switch, modem, router or device and the other to the destination port (wall outlet, patch panel, keystone jack or another device). Ensure connectors are fully seated until the latch clicks. Route the cable without sharp bends and avoid tight kinks; use the strain-relief boot when pulling the cable through confined installation spaces to protect the connector.

Recommendations

For reliable performance maintain bend radius and avoid running the cable parallel and close to power lines or high-voltage cables. Use the red colour to identify specific connections in patch panels or racks. The cable is intended for indoor use; avoid prolonged exposure to moisture and direct sunlight.