Naulapistoolin naula Bosch 1609200376 tyyppi 47 pituus 16 mm määrä 1000 kpl

Brad nail Bosch 1609200376 Type 47 is a hard-steel wire nail designed for tacking thin and thicker materials. This pack contains 1,000 nails, each 16 mm long, compatible with machines that accept Type 47 brads. The head width varies by tool and may be 1.8 mm or 2.8 mm depending on the tacker model.

Advantages

Type 47 brad nails are made from hardened steel wire for consistent penetration and holding power. Their 16 mm length is suitable for precise woodworking and trim work. The nails are supplied in a large quantity (1,000 pcs), reducing the need for frequent reloading. Compatibility with a wide range of brands increases versatility across different manual and pneumatic tackers.

Suitable for

Key specifications

How to use

Load the appropriate Type 47 brad strip into a compatible tacker following the tool manufacturer's loading instructions. Set the tacker depth and air pressure (for pneumatic models) according to the material being fastened. Position the tip against the workpiece, press firmly, and actuate the tool to drive the 16 mm brad into the material. Ensure nails are driven flush or slightly countersunk as required for finishing.

Recommendations

Use these Bosch Type 47 brads with tackers listed as compatible (AEG, Bosch, Esco, Kwb, Lux, Mekano, Metabo, Novus, Peugeot, Rocafix, Rocagraf, Stanley, Swingline, Wolfcraft). For best results on thin materials, test on scrap to adjust depth and pressure to avoid splitting or over-penetration.