Optinen SFP-moduuli Lanview MO-UACC-OM-SFP10-1270

Lanview MO-UACC-OM-SFP10-1270 is an optical SFP transceiver module designed for insertion into SFP ports of switches, routers and media converters to provide single-mode fiber connectivity. The module enables a 10 km-class optical link at a nominal wavelength of 1270 nm, allowing network equipment to establish or restore fiber uplinks without replacing the host device. Supplied as a single SFP module, it is compatible with devices that accept standard SFP form-factor transceivers and supports hot-plug installation.

Advantages

This optical SFP module offers straightforward compatibility with common SFP-capable network equipment and supports hot-swap installation to minimise downtime. The compact SFP form factor conserves chassis port space while providing a fiber uplink option for data, management or uplink interfaces. Built for single-mode fiber applications at the specified wavelength, it provides a reliable physical layer option for extending network segments over longer distances than copper cabling allows.

Suitable for

• Establishing single-mode fiber uplinks between switches and routers
• Replacing faulty or incompatible SFP transceivers in existing network devices
• Connecting media converters, optical line cards and access switches over fiber
• Deployments requiring point-to-point fiber links up to typical short-haul distances

Key specifications

• Form factor: SFP (small form-factor pluggable)
• Optical type: single-mode fiber
• Wavelength: 1270 nm (nominal)
• Typical reach: short to medium single-mode distances (manufacturer guidance applies)
• Connector type: LC duplex compatible
• Hot-pluggable: yes

How to use

Power off or put the host device into a safe maintenance state if required by your hardware procedures, then insert the SFP module into an empty SFP port until it seats firmly. Connect LC duplex single-mode fiber patch cables to the module's optical ports, observing transmit and receive orientation. Configure the host device network interface as needed for link speed, duplex and optical diagnostics through the device's management interface. Test the link and monitor optical status to confirm proper operation.

Recommendations

When installing or replacing SFP modules, ensure the host device supports third-party SFP transceivers. Use clean fiber patch cords and dust caps to protect optical interfaces, and verify fiber type and wavelength compatibility with the remote link endpoint. Follow ESD precautions and handle the module by its housing to avoid contamination of the fiber ports.