SDS-plus-poravasaranteräsarja Bosch EXPERT Clean plus-8X 6x100x225 mm

Bosch EXPERT SDS-plus Clean plus-8X 6x100x225 mm is a set of hammer drill bits designed for use with SDS-plus rotary hammers. The bits are intended for percussion drilling in concrete and masonry where consistent drilling depth, effective dust and chip evacuation, and reliable bit life are required. The geometry and flute design are optimized to reduce clogging and to maintain drilling efficiency on both reinforced and non-reinforced materials.

Advantages

The set combines a durable carbide tip with a flute profile that promotes fast removal of debris and reduced friction during drilling. Compatibility with SDS-plus chucks ensures secure bit retention and quick bit changes. The bit length and working diameter provide a balance between reach and control for typical construction and renovation tasks. Materials and finishing contribute to longer service life compared with standard twist bits when used in appropriate hammer drilling applications.

Suitable for

• Percussion drilling in concrete and masonry
• Drilling for anchor bolts and dowels
• Installing electrical boxes and conduit in walls
• General construction and renovation tasks requiring SDS-plus tools

Key specifications

• Shank type: SDS-plus compatible
• Tip material: carbide tip for impact drilling
• Diameter: 6 mm
• Working length: 100 mm
• Total length: 225 mm
• Flute design: optimized for chip evacuation in masonry
• Intended use: percussion (hammer) drilling

How to use

Insert the SDS-plus shank into the rotary hammer's chuck until it locks, then select the hammer drilling mode. Position the bit perpendicular to the work surface and start drilling at low speed to create a guide recess, then apply steady pressure while allowing the tool to deliver impact blows; avoid excessive lateral force. Periodically withdraw the bit to clear accumulated dust and allow the flute design to evacuate debris. Use correct safety equipment, including eye protection, hearing protection, and dust control measures when drilling in concrete or masonry.

Recommendations

For best results, match the bit diameter and working length to the required hole depth and anchor size; when drilling reinforced concrete, use controlled pressure and allow the bit to cool periodically. Replace bits that show significant wear or chipping of the carbide tip to maintain drilling accuracy and reduce the risk of breakage.