SFP-lähetin-vastaanotin BlueOptics TRX100027-BO 1250 Mbit/s 1550 nm

The BlueOptics TRX100027-BO 1250 Mbit/s 1550 nm is an SFP transceiver module designed for fiber optic networks. It supports a maximum data transfer rate of 1250 Mbit/s and transmits at a wavelength of 1550 nm. The module comes in a metal housing with a silver finish and weighs approximately 20 g, combining compact dimensions with mechanical robustness for rack and chassis installations.

Advantages

This SFP transceiver provides a standardized SFP interface for hot-swappable installation, enabling flexible upgrades of network equipment without system downtime. The metal housing improves shielding and heat dissipation, while the low weight simplifies handling during installation. Support for 1550 nm wavelength makes the module suitable for longer-reach single-mode fiber links when paired with compatible optics and fiber.

Suitable for

• Upgrading switches, routers or media converters with SFP ports
• Single-mode fiber links requiring 1550 nm transmission
• Point-to-point connections in LAN and MAN networks
• Environments where compact, hot-swappable transceivers are required

Key specifications

• Interface type: SFP
• Maximum data transfer rate: 1250 Mbit/s
• Operating wavelength: 1550 nm
• Housing material and colour: metal, silver
• Weight: 0.02 kg

How to use

Ensure compatible SFP slot and matching fiber type before installation. Handle the module by the housing, avoid touching the optical connector, and remove protective caps only when ready to insert. Slide the transceiver into the SFP port until it seats and engages the latch mechanism. Connect the appropriate single-mode fiber cable, verify link LEDs on the host device, and configure network settings as required by your equipment.

Recommendations

Store and operate the module within recommended temperature and humidity ranges of your network equipment. Use compatible single-mode fiber and confirm wavelength and power budget for link distance planning. For best results, keep connectors clean and inspect fiber ends with appropriate tools before connecting.