SFP-lähetin-vastaanotinmoduuli BlueOptics 10072H-BO 1250 Mbit/s kuitu

The BlueOptics 10072H-BO SFP transceiver module is designed for fiber optic network links that require a 1.25 Gigabit Ethernet interface and a data rate up to 1250 Mbit/s. Compact and lightweight at 20 g, the module uses an LC (UPC) fiber connector and supports single-mode connections with a maximum reach of up to 10,000 m. Its silver finish and standardized SFP form factor make it compatible with many switches and media converters that accept hot-pluggable SFP modules.

Advantages

The module delivers a stable 1250 Mbit/s throughput suitable for backbone and access links over single-mode fiber. With an MTBF of around 1,000,000 hours, it provides long operational lifetime expectations for continuous network deployment. The small SFP package and low weight simplify installation and reduce strain on equipment ports. The LC (UPC) connector provides reliable ferrule alignment for low insertion loss and consistent optical performance.

Suitable for

• Single-mode fiber uplinks between switches and routers
• Media converters and SFP-capable devices in enterprise networks
• Long-distance point-to-point fiber links up to 10 km
• Network segments requiring 1.25 Gigabit Ethernet connectivity

Key specifications

• Maximum data transfer rate: 1250 Mbit/s
• Maximum transfer distance: 10,000 m (single-mode)
• Ethernet interface type: 1.25 Gigabit Ethernet (SFP)
• Fiber optic connector: LC (UPC)
• Weight: 0.02 kg
• Product colour: Silver
• Mean time between failures (MTBF): 1,000,000 hours

How to use

Power down or follow the hot-swap procedure prescribed by your equipment vendor, then insert the BlueOptics SFP module into an SFP slot until it seats securely. Connect LC-terminated single-mode fiber patch cords to the module, ensuring correct transmit/receive orientation. After installation, verify link status and configure interface settings on the host device as required for 1.25 Gigabit operation. Observe manufacturer guidelines for electrostatic discharge protection while handling the module.

Recommendations

Use single-mode LC (UPC) patch cords certified for the intended distance and maintain clean connector endfaces to minimize optical loss. Confirm compatibility with the host device's SFP policy and firmware; consult equipment documentation for supported transceiver models and interface configuration. Store the module in a dust-free environment when not in use and avoid mechanical stress on fiber connections.