SFP-lähetin-vastaanotinmoduuli BlueOptics 506724-BO 1250 Mbit/s kuitu

The BlueOptics 506724-BO SFP transceiver module provides a compact fiber optic interface for network equipment with a maximum data transfer rate of 1250 Mbit/s. Housed in a silver metal enclosure and conforming to the SFP form factor, this module is intended for insertion into compatible SFP ports on switches, routers or media converters. The product weight is 20 g and the manufacturer specifies a mean time between failures (MTBF) of 1,000,000 hours, indicating its design for sustained operation in network environments.

Advantages

The SFP form factor enables hot-pluggable deployment in standard SFP slots, allowing easy replacement or upgrade without powering down equipment. With a rated throughput of up to 1250 Mbit/s, the module supports common fiber-based network links. Its metal casing in silver offers mechanical protection and helps dissipate heat, while the lightweight design reduces strain on device ports. The high MTBF figure reflects a focus on longevity and reliable service in continuous-use scenarios.

Suitable for

• Establishing fiber optic uplinks between switches and routers
• Connecting media converters or optical patch panels
• Replacing or upgrading existing SFP fiber ports in enterprise and SMB networks
• Use in laboratory or testing setups that require standard SFP modules

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Interface type: Fiber optic SFP
• Housing material and colour: metal, silver
• Weight: 0.02 kg
• Operational reliability indicator: MTBF 1,000,000 hours

How to use

Ensure the target device supports SFP fiber transceivers and is powered according to the device manufacturer instructions. Carefully insert the BlueOptics 506724-BO module into an empty SFP slot until it locks in place. Connect the appropriate fiber cable to the module's optical interface, observing correct connector types and fibre polarity. After connection, verify link status through the host device's indicator LEDs or management interface and configure port settings such as speed or duplex if required by the network equipment.

Recommendations

Handle the transceiver using ESD precautions and protect the optical ports with dust caps when not connected. Use compatible multimode or single-mode fiber and connectors as required by the specific network design; check connector and fiber specifications before installation. For reliable operation, avoid excessive mechanical stress on the module and connected cables and follow the host device's thermal and environmental guidelines.