SFP+-lähetin-vastaanotinmoduuli BlueOptics AT-SP10LRA/I-BO 10000 Mbit/s

The BlueOptics AT-SP10LRA/I-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s networks. It uses an LC duplex connector and single-mode fiber optics, supports a 10,000 Mbit/s data rate and is housed in a durable silver metal casing. The module is lightweight (approx. 20 g) and has a high mean time between failures (MTBF) of 1,000,000 hours to provide long-term operation in network environments.

Advantages

This transceiver adheres to MSA-compatible SFP+ form-factor standards for broad interoperability and physical compatibility with equipment that supports 10G SFP+ modules. The metal housing offers mechanical stability and thermal dissipation while the module’s lightweight design simplifies handling and installation. Its specified MTBF indicates suitability for continuous operation and reduced maintenance intervals.

Suitable for

• 10 Gigabit Ethernet uplinks and inter-switch links
• High-speed connections between switches, routers, and storage systems
• Longer-distance single-mode fiber links within campus and carrier networks

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s
• Connector type: LC duplex (single-mode fiber)
• Housing: metal, silver colour
• Weight: 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours

How to use

Insert the SFP+ transceiver into a compatible SFP+ slot on a switch, router or other network device while the device is powered down or following the manufacturer’s hot-plug guidelines. Connect the LC duplex single-mode fiber patch cable ensuring correct Tx/Rx orientation. Verify link status and data rate through the host device’s interface. If the device supports Digital Diagnostics Monitoring (DDM/DOM), enable or check diagnostics via the host system to monitor parameters such as optical power and temperature where supported.

Recommendations

Use single-mode LC duplex fiber patch cords rated for 10G operation and follow the equipment vendor’s compatibility list. Ensure fiber connectors are clean and that patch cords are routed to avoid sharp bends. Confirm that the host hardware supports SFP+ modules of this specification and, if remote diagnostics are required, that DDM/DOM is enabled and supported by the host device.