SFP-lähetin-vastaanotinmoduuli BlueOptics H-BX20-SFP-D-BO 1250 Mbit/s

The BlueOptics H-BX20-SFP-D-BO is an SFP transceiver module for single-mode fiber links supporting a maximum data transfer rate of 1250 Mbit/s. Housed in a compact metal enclosure with a silver finish and weighing approximately 20 g, the module implements the 1000BASE-BX-D type transmission with separate transmitter and receiver wavelengths suitable for long-reach optical connections. The module conforms to CE, RoHS and FCC standards and follows MSA physical form-factor conventions to ensure interoperability with compatible networking equipment.

Advantages

The BlueOptics transceiver provides a standardized SFP interface in a metal housing that supports 1.25 Gbit/s Ethernet-class links over single-mode fiber. Compliance with common regulatory standards and the MSA specification ensures compatibility and predictable mechanical and electrical behavior in switches, routers and other network platforms. Its lightweight design and LC simplex optical connector make it easy to install and integrate into existing fiber patching and rack systems.

Suitable for

Key specifications

How to use

Install the transceiver into an SFP slot of a compatible switch, router or other network device while the host equipment is powered down or following the vendor's hot-swap guidance. Connect an appropriate single-mode LC simplex patch cable between transceivers at each end of the link, respecting the directional wavelengths for transmit and receive. After insertion and link-up, verify signal presence and link status via the host device management interface. If available and supported by the host, use Digital Diagnostics Monitoring (DDM/DOM) to read real-time module parameters such as output power and temperature for diagnostic purposes.

Recommendations

Use high-quality single-mode LC simplex patch cords and ensure both ends of the link use compatible BX-D type transceivers (matching transmit and receive wavelengths). Verify DDM/DOM support on the host device to enable remote monitoring. Observe proper fiber handling and clean connector endfaces before connection to maintain link performance and reduce insertion loss.