SFP-lähetin-vastaanotinmoduuli BlueOptics SFP-BXU35-20KM-IX-BO 1250 Mbit/s

The BlueOptics SFP-BXU35-20KM-IX-BO is an SFP fiber optic transceiver module designed for point-to-point and metro networking links. Supporting a maximum data transfer rate of 1250 Mbit/s, the module is housed in metal with a compact SFP form factor and a lightweight design of approximately 20 g. With a rated mean time between failures (MTBF) of 1,000,000 hours, this transceiver is intended for reliable single-mode fiber connections over extended distances.

Advantages

The metal housing provides mechanical robustness and thermal stability, while the standard SFP interface ensures compatibility with a wide range of switches and routers that accept SFP modules. A data rate of 1250 Mbit/s supports common legacy and access network applications. The module’s low weight and compact dimensions facilitate easy installation in dense patch panels and SFP cages. A high MTBF value indicates long operational life under normal conditions.

Suitable for

Key specifications

How to use

Install the module into an SFP slot on compatible network equipment while the device is powered down or in accordance with the manufacturer’s hot-swap procedures. Ensure the SFP is fully seated until the latch engages. Connect the appropriate single-mode fiber cable to the transceiver’s optical port, observing correct TX/RX orientation. Configure the network device for the required link speed and duplex settings if manual configuration is needed. Verify link and activity LEDs on the host equipment to confirm an operational connection.

Recommendations

Use with compatible single-mode fiber cables and ensure connectors are clean before mating. Avoid exposing the transceiver to excessive dust, moisture, or shock during handling. Follow the host equipment vendor’s guidelines for supported transceiver modules and firmware compatibility to ensure stable operation.