SFP28-lähetin-vastaanotinmoduuli BlueOptics SFP28-25G-ER-ZY-BO 25000 Mbit/s 1310 nm

The BlueOptics SFP28-25G-ER-ZY-BO is a single-port fiber optic transceiver module designed for 25 Gbps links using an SFP28 interface. Operating at a nominal wavelength of 1310 nm, this compact module provides a lightweight solution (approx. 20 g) for high-bandwidth connections in data centers and enterprise networks. It supports standard SFP28 form-factor installation and is intended for use in compatible switches, routers and optical equipment that accept SFP28 modules.

Advantages

This SFP28 transceiver offers 25 Gbit/s line-rate performance over single-mode fiber at 1310 nm, enabling high-throughput links while maintaining a compact SFP28 form factor. Its lightweight design simplifies hot-swap installation and reduces handling constraints in dense equipment racks. The module is suitable for deployments where small size, standardized interface and consistent optical wavelength are required for interoperability.

Suitable for

• 25 Gbps short- and extended-reach single-mode fiber links in data centers
• High-bandwidth uplinks between switches and aggregation equipment
• Server-to-switch or switch-to-switch optical connections requiring SFP28 ports

Key specifications

• Interface type: SFP28 form factor
• Maximum data transfer rate: 25,000 Mbit/s (25 Gbps)
• Operating wavelength: 1310 nm
• Weight: approximately 0.02 kg
• Single-port fiber optic transceiver suitable for single-mode fiber

How to use

Install the module into any compatible SFP28 slot on a switch, router or optical transceiver bay while the host device is powered down or following the equipment vendor's hot-swap procedures. Ensure the mating fiber connectors and patch cables are appropriate for 1310 nm single-mode operation and that the link settings on both ends (speed, duplex and auto-negotiation where applicable) match. Monitor link status via the host device's management interface to verify proper operation after insertion.

Recommendations

Use factory-tested single-mode fiber patch cords and ensure connectors are clean before mating. Follow equipment vendor compatibility lists and observe electrostatic discharge precautions during handling. For reliable 25 Gbps performance, verify that the connected transceivers and fiber plant support the intended reach and optical power budget.