UTP-patchkaapeli QOLTEC CAT6 50 m kupari (Cu) harmaa

UTP patchcord cable QOLTEC CAT6 50 m with a copper conductor and grey jacket provides a flexible, single-ended reel solution for Ethernet networking and structured cabling. Built to CAT6 specification, this cable supports Gigabit Ethernet and common LAN applications in home, office, or server-room environments. The 50 m length and unshielded twisted pair construction make it suitable for horizontal cabling runs, patching between switches and patch panels, and on-site adjustments during installation.

Advantages

The cable combines CAT6 performance with a solid copper conductor to ensure consistent signal transmission and reduced attenuation over longer runs compared to copper-clad alternatives. The unshielded twisted pair design offers reliable operation in typical indoor environments while maintaining flexibility for easy handling and routing. Its neutral grey jacket blends with most installations and the single-ended reel format simplifies cable deployment and cutting to length at the installation site.

Suitable for

Key specifications

How to use

Measure the required run and unroll the cable from the reel, allowing slightly more length than the measured distance to accommodate routing and termination. Strip the outer jacket carefully to expose the twisted pairs, maintain pair twist as much as possible, and terminate using appropriate CAT6 compatible RJ45 connectors or keystone jacks following standard wiring schemes (T568A or T568B). For patching, cut to desired length, terminate both ends, and label each run if required. Avoid tight bends and secure the cable with appropriate clips or ties without crushing the jacket.

Recommendations

For optimal performance, keep cable runs under recommended distances for Ethernet standards, avoid running parallel to high-voltage power cables, and maintain correct pair twists during termination. Use proper cable testers after installation to verify continuity and performance for Gigabit Ethernet.