Verkkokaapeli LogiLink 10 m RJ-45 Cat6 F/UTP harmaa

LogiLink 10m RJ-45 Cat6 F/UTP grey patch cable provides a 10-metre connection for network devices using RJ45 connectors on both ends. This Cat.6 F/UTP (foil-shielded twisted pair) cable is designed to reduce electromagnetic interference and support high-speed data transmission. The conductors are copper-clad aluminium with a flexible PVC jacket and the cable follows TIA/EIA-568B wiring standard.

Advantages

The shielded F/UTP design lowers crosstalk and external interference compared with unshielded cables. RJ45 terminations ensure compatibility with standard network ports. Copper-clad aluminium conductors offer a balance between conductivity and cost, while the flexible PVC jacket makes the cable easier to route and install in confined spaces.

Suitable for

• Connecting computers, switches and routers in home or office networks
• Wiring patch panels and wall outlets in structured cabling
• Short- to medium-length runs where EMI protection is beneficial

Key specifications

• Category: Cat.6
• Shielding: F/UTP (foil shielded twisted pair)
• Length: 10 m
• Conductors: copper-clad aluminium (AWG 26/7)
• Connectors: RJ-45 — both ends
• Jacket: flexible PVC
• Weight: 0.3 kg
• Standard: TIA/EIA-568B

How to use

Plug each RJ45 connector into the corresponding network port on your devices (for example, computer to switch or router). Ensure connectors are fully inserted until the latch clicks. Route the cable to avoid sharp bends and heavy compression to maintain signal integrity. For installation into patch panels or keystone jacks, verify wiring order matches the TIA/EIA-568B standard.

Recommendations

For optimal performance, keep cable runs below recommended maximum lengths for your network equipment and avoid running the cable parallel to high-voltage power lines to reduce interference. Inspect connectors for damage before installation and replace the cable if the jacket or connectors are compromised.