Virtalähde INTER-TECH SDS 12-60 12V 60W

INTER-TECH SDS 12-60 is an AC-to-DC power supply that delivers a regulated 12 V DC output with a maximum power of 60 W. The compact unit is designed to provide stable low-voltage power for a variety of electronic devices and installations where consistent 12 V supply is required. Its small form factor allows mounting inside control panels, small enclosures or within LED system housings while maintaining reliable voltage regulation under typical load conditions.

Advantages

The power supply offers regulated 12 V output to reduce voltage fluctuations and protect connected devices. Its 60 W power rating supports multiple low-voltage loads simultaneously while the compact design enables installation in space-constrained environments. Built for continuous operation, the unit provides a stable DC source suitable for electronics that need consistent supply voltage.

Suitable for

• LED lighting systems and LED drivers
• Network equipment such as routers and switches
• Control panels and automation modules
• Small embedded systems and single-board computers
• Security devices including cameras and sensors

Key specifications

• Output voltage: 12 V DC
• Maximum output power: 60 W
• Output current: up to 5 A
• Input: AC mains compatible (standard voltage range for line operation)
• Form factor: compact housing suitable for panel or enclosure mounting
• Regulation: stabilized DC output for reduced ripple and voltage variation

How to use

Install the INTER-TECH SDS 12-60 in a ventilated enclosure or on a suitable mounting surface, ensuring access to AC mains and the DC output terminals. Connect the AC input according to local electrical codes and attach the 12 V DC output to the device or distribution wiring, observing correct polarity. Verify that the combined current draw of connected devices does not exceed the unit's 5 A rating. After connections are secured, power up the unit and confirm stable 12 V output before connecting sensitive electronics.

Recommendations

Place the power supply in a dry, ventilated location with ambient temperature within the manufacturer's specified range. Avoid overloading the unit and allow adequate clearance for cooling. When installing in equipment racks or enclosures, route wiring to minimize interference and use appropriate fusing on the DC output if local safety regulations require it.