XFP-lähetin-vastaanotinmoduuli BlueOptics FXFP13-10-BO 10000 Mbit/s

The BlueOptics FXFP13-10-BO is an XFP transceiver module designed for high-speed single‑mode fiber networks. It supports a maximum data transfer rate of 10000 Mbit/s and uses an LC duplex optical interface according to MSA XFP form‑factor standards. The module is lightweight (approximately 4 g) and intended for installation in compatible XFP slots of switches, routers, storage systems and similar network hardware that support 10GBASE‑LR XFP modules.

Advantages

The module provides 10 Gbit/s optical transmission over single‑mode fiber with separate transmit and receive wavelengths configured for long‑reach links. It follows MSA specifications for XFP form factor and LC duplex connectivity to ensure mechanical and electrical compatibility with compliant network equipment. Digital diagnostics (DDM/DOM) support is available when the host hardware implements the required interface, enabling monitoring of parameters such as supply voltage, laser bias current, optical output and input power, and temperature. The compact, low‑weight design simplifies installation and replacement in dense network deployments.

Suitable for (tasks / use cases)

Key specifications

How to use

Install the BlueOptics FXFP13-10-BO into a compatible XFP slot following the host device manufacturer’s installation instructions and safety guidelines. Connect LC duplex single‑mode fiber patch cords, observing correct TX/RX orientation and using appropriate patch panels or direct cabling between transceivers. Ensure the connected equipment is configured for 10G operation and that any required firmware or software settings for third‑party transceivers are applied. If digital diagnostics are needed, confirm that the host device supports DDM/DOM and use its management interface to monitor operational parameters.

Recommendations

Use high‑quality single‑mode fiber and LC duplex patch cords to achieve the specified range and signal quality. Verify compatibility with the host hardware and, if possible, perform a test installation to confirm link operation before large‑scale deployment. Observe electrostatic discharge (ESD) precautions during handling and keep optical connectors clean to maintain optimal performance.