ACT 10 m LSZH multimode 50/125 OM2 kuituverkkokaapeli duplex LC- ja ST-liittimillä

The ACT 10 meter LSZH Multimode 50/125 OM2 Duplex LC ST fiber patch cable provides a 10 m multimode link with LC and ST terminations designed for indoor network environments. Constructed with LSZH jacket material, the cable reduces smoke and halogen emissions in case of fire. The 50/125 µm core/cladding dimensions correspond to OM2 multimode performance and the duplex configuration supports simultaneous bidirectional data transmission between connected devices.

Advantages

This fiber patch cable combines a 10 meter reach with multimode OM2 performance, duplex connectivity and a mix of LC and ST connectors to suit a range of equipment. The LSZH outer jacket improves safety for indoor and confined-space installations by minimizing toxic and corrosive smoke. The duplex construction allows full-duplex communication, supporting efficient network traffic and simple point-to-point connections.

Suitable for

• Connecting servers, switches and patch panels within data centers and wiring closets
• Indoor backbone or horizontal runs in enterprise networks
• Linking multimode transceivers and equipment that use LC and ST interfaces

Key specifications

• Length: 10 meters
• Fiber type: Multimode OM2 (50/125 µm)
• Jacket material: LSZH (Low Smoke Zero Halogen)
• Connector configuration: Duplex
• Connectors: LC on one end, ST on the other
• Transmission mode: Full duplex

How to use

Install the cable by aligning and inserting the LC connector into the corresponding LC port on one device and the ST connector into the ST port on the other device, ensuring connectors are clean and free of dust before connection to avoid signal loss. Route the cable along existing cable management pathways, avoiding tight bends and sharp edges; maintain the manufacturer’s recommended minimum bend radius for multimode fiber. Secure the cable with appropriate fasteners without compressing the jacket and verify link status using network diagnostics or optical test equipment after connection.

Recommendations

For reliable performance, clean connector endfaces before each connection, avoid excessive bending or tensile stress, and use this OM2 multimode cable for short- to medium-distance indoor links where LC and ST interfaces are required. Store the cable coiled loosely and protect connectors with dust caps until installation.