AOC SFP+ aktiivinen optinen kaapeli CBO CBL-SFP+AOC-10M 10 m pituus

AOC CBO CBL-SFP+AOC-10M is a 10 m SFP+ Active Optical Cable designed to provide a direct-attach optical link for 10 Gigabit Ethernet and Fibre Channel environments. The cable integrates active optical transceivers into an assembly with SFP+ connectors on both ends, enabling a compact, low-latency connection between switches, servers and storage equipment without separate transceiver modules. Its 10 metre reach addresses short to mid-range data centre interconnects where reduced power consumption and improved signal integrity are required compared with equivalent copper DACs.

Advantages

The AOC design delivers lower power consumption and heat generation than comparable copper direct attach options while maintaining 10GbE and Fibre Channel performance. Built-in SFP+ connectors simplify installation and eliminate the need to purchase or populate separate transceiver modules, reducing hardware complexity. Optical transmission provides immunity to electromagnetic interference and consistent signal quality over the full 10 m length, supporting reliable high-speed links in dense rack and row deployments.

Suitable for

• Switch-to-switch connections in data centres and network racks
• Server-to-switch uplinks for 10 Gigabit Ethernet
• Storage array interconnects for Fibre Channel and SCSI over 10GbE
• Short-distance optical links where active, low-power cabling is required

Key specifications

• Interface: SFP+ connectors on both ends
• Length: 10 metres
• Supported link rates: 10 Gigabit Ethernet and Fibre Channel
• Cable type: Active Optical Cable (AOC)
• Latency: low, suitable for latency-sensitive network applications
• Electrical/optical properties: designed for reduced power consumption compared with passive copper DACs

How to use

Insert each SFP+ connector into the corresponding SFP+ port on network switches, servers or storage devices until the connector latches. Ensure both ends sit firmly in their ports and that the host devices are powered and configured for 10GbE or compatible Fibre Channel speeds. No additional optical transceivers or patch cords are required. If a device does not recognize the cable, verify port compatibility and firmware settings; in managed environments, confirm link negotiation and speed settings on both ends.

Recommendations

Install the cable following standard data centre handling procedures: avoid tight bends, maintain the manufacturer’s recommended bend radius, and secure the cable to prevent strain on the connectors. Use in rack or row topologies for short to medium runs where a compact, energy-efficient 10GbE or Fibre Channel connection is needed. Verify device compatibility if vendor-specific link validation is enforced.