BlueOptics SFP-10G-LR-AU-BO verkon lähetin-vastaanotinmoduuli kuitu 10 000 Mbit/s SFP+

The BlueOptics SFP-10G-LR-AU-BO network transceiver module is a fiber optic SFP+ device designed to support 10 Gbit/s connectivity for long-reach links. Housed in a durable metal enclosure and weighing approximately 20 g, this module provides a compact interface for integrating high-speed optical connections into switches, routers or media converters. It meets common regulatory standards for electronic components and is intended for stable, low-maintenance network operation.

Advantages

This SFP+ transceiver offers a standard SFP+ interface that is compatible with a wide range of network equipment supporting small form-factor pluggable modules. The metal housing provides physical protection and thermal dissipation while the lightweight design simplifies installation in dense rack environments. Compliance with RoHS and FCC standards ensures it meets environmental and electromagnetic requirements typical for professional networking installations.

Suitable for

Key specifications

How to use

Install the module by inserting the SFP+ transceiver into a compatible SFP+ port until it clicks into place, observing correct orientation and ensuring the host equipment is powered and configured to recognize SFP+ modules. Connect appropriate single-mode or multimode fiber cables with matching connectors to the transceiver’s optical interface. Configure network settings on the switch or router to enable the 10 Gbit/s link and verify link status through the device management interface or diagnostic LEDs. Remove the module by depressing the release latch before pulling it from the port.

Recommendations

Use factory-tested fiber cables and maintain clean connector end-faces to ensure optimal signal integrity. Verify compatibility with your host equipment manufacturer’s supported SFP+ modules list if required. Handle the transceiver by its housing and avoid touching optical interfaces; store unused modules with protective dust caps.