SFP+-kaapeli CBO 2127931-2-BL 1 m uros-uros 10 Gbit/s

This CBO SFP+ cable (1 m, male-to-male) provides a short-reach direct-attach link for devices with compatible SFP+ ports. Supporting 10 Gbit/s data rates, the cable is intended for high-speed connections between switches, servers and other network equipment in data centres and enterprise environments. Its fixed 1 metre length and male-to-male SFP+ connectors simplify installation where a compact, low-latency copper connection is required.

Advantages

The cable offers a straightforward, low-latency connection with full 10 Gbit/s throughput for short-distance links. Its pre-terminated assembly removes the need for separate transceivers and reduces component count in rack deployments. The compact form factor conserves space in dense equipment layouts and reduces cable management complexity while delivering consistent electrical performance for compatible SFP+ ports.

Suitable for

• Connecting adjacent switch-to-switch links in racks
• Direct server-to-switch connections inside cabinets
• Top-of-rack and end-of-row short-reach network links
• Environments requiring predictable 10 Gbit/s performance with minimal latency

Key specifications

• Interface: SFP+ male to SFP+ male
• Data rate: 10 Gbit/s
• Length: 1 metre
• Cable type: Direct-attach (copper) assembly for short-reach links
• Application: Short-distance high-speed interconnects for networking equipment

How to use

Insert each SFP+ connector into the SFP+ cage of the corresponding network device until the latch engages. Ensure devices are powered and configured to accept direct-attach copper links or to autodetect the connection type. Route the cable to avoid sharp bends and mechanical strain; secure it to cable management points if required. Verify link status and speed in the device management interface to confirm 10 Gbit/s operation.

Recommendations

For reliable operation, use this direct-attach cable for distances within typical short-reach limits and between compatible SFP+ ports. Avoid excessive bending near the connector ends and maintain separation from sources of electromagnetic interference. Check device documentation for supported direct-attach assemblies and any required firmware or configuration settings prior to deployment.