CBO AOC SFP28 BlueOptics BO272703Q7M aktiivinen optinen kaapeli 7 m

The CBO AOC SFP28 BlueOptics BO272703Q7M active optical cable 7 m is an SFP28 direct-attach solution that delivers 25 Gb/s full-duplex connectivity over a 7-meter optical link. Designed for use with SFP28 ports, this active optical cable integrates transceivers and a fiber link into a single assembly to provide low-latency, high-bandwidth interconnection between servers, switches and storage devices in data centers and telecom racks. The cable offers immunity to electromagnetic interference and eliminates the need for separate transceiver modules and patch fiber for short-reach connections.

Advantages

This active optical cable supports 25 Gb/s signaling with a compact SFP28 form factor, providing reliable short-reach links with low latency. The integrated design reduces rack cabling complexity and minimizes signal loss compared with multi-segment assemblies. EMI immunity and optical transmission ensure stable performance in dense rack environments. Passive installation requires no additional power sources beyond the host ports and simplifies deployment in top-of-rack and end-of-row configurations.

Suitable for

• Interconnecting SFP28 ports between servers and top-of-rack switches
• High-performance storage networking and SAN links
• Data center patching and short-reach telecom rack connections
• Environments requiring EMI-resistant links and low-latency communication

Key specifications

• Connector type: SFP28 duplex
• Data rate: 25 Gb/s per link (full duplex)
• Length: 7 meters
• Media: active optical fiber integrated in cable assembly
• Latency: low propagation delay suitable for short-reach interconnects
• Immunity: resistant to electromagnetic interference due to optical transmission
• Form factor: hot-pluggable SFP28 compatible

How to use

Install the active optical cable by inserting each SFP28 connector into the corresponding SFP28 port on the network devices until the latch engages. Ensure devices are powered and configured to operate at 25 Gb/s where required; link negotiation is typically handled by the host equipment. Route the 7 m cable through the rack to avoid sharp bends and mechanical strain on connectors. No separate transceivers or patch fibers are required, and no external power supply is needed for the cable assembly.

Recommendations

Inspect connector endfaces before insertion and keep protective caps until ready to deploy. Maintain bend radius according to manufacturer guidance, avoid excessive tension, and secure the cable to prevent movement. Verify interoperability and firmware compatibility with host equipment when deploying in mixed-vendor environments.