Fischer 50367 naulakiinnike N 6 x 40 D A2 (50 kpl)

Fixing battens, substructures, wall connection profiles, cable and pipe clamps to concrete or masonry usually means pre-drilling, then hammering in a separate plug and screw. The Fischer 50367 nail anchor combines the plug and the screw into one stainless steel unit, so you can install it through the fixture with a few hammer blows and immediately tighten the countersunk head.

Who is it for

Electricians, plumbers, carpenters and metalworkers who need fast, reliable through-fixing in solid building materials. The A2 stainless steel version is suitable for indoor and outdoor use, including damp or humid environments.

Main features

• Nail anchor with integrated countersunk head for through-fixing
• Stainless steel A2 (AISI 304) for high corrosion resistance
• 6 mm diameter, 40 mm length, 50 pieces per pack
• Approved for concrete, solid brick, solid sand-lime brick, aerated concrete, natural stone and solid lightweight concrete blocks
• Quick hammer-in installation, no separate plug required

Specifications

• Anchor type: Nail anchor
• Material: Stainless steel A2
• Nominal diameter: 6 mm
• Anchor length: 40 mm
• Drill hole diameter: 6 mm
• Minimum drill hole depth: 50 mm
• Maximum usable length: 10 mm
• Head type: Countersunk head
• Installation method: Through-fixing (hammer-in)
• Quantity per pack: 50 pieces
• Suitable for: Concrete, solid brick, solid sand-lime brick, aerated concrete, natural stone, solid lightweight concrete blocks

Tips

Drill the hole to the specified depth and clean out the dust before hammering in the anchor. For maximum holding power, make sure the fixture is pressed firmly against the base material while you drive the nail.