InLine Solid-asennuskaapeli SF/UTP Cat.5e AWG24 CU PVC 50 m

The InLine Solid Installation Cable SF/UTP Cat.5e AWG24 CU PVC 50m is a 50-metre single-conductor network cable designed for structured cabling in residential and commercial environments. It supports data rates up to 10000 Mbit/s and is built with SF/UTP shielding to reduce electromagnetic interference. The cable has a PVC outer jacket and a beige colour suitable for unobtrusive installation in walls, conduits and patch panels.

Advantages

The solid AWG24 copper conductor provides consistent signal transmission for long runs, while SF/UTP shielding improves immunity to external noise sources and adjacent cables. The PVC jacket offers flexibility during installation and protects the cable from abrasion and general wear. Absence of pre-fitted connectors allows termination to be performed on-site to match local installation requirements and connector types.

Suitable for

• Structured cabling for offices, server rooms and data closets
• Permanent horizontal and vertical cabling runs inside buildings
• Installation where SF/UTP shielding is required to limit EMI
• Custom-terminated patch panels and wall outlets

Key specifications

• Category: Cat.5e (enhanced)
• Cabling technology: 10/100/1000Base-T(X)
• Conductor type: Solid copper, AWG24
• Shielding: SF/UTP (foil with braided screen around pairs or overall as applicable)
• Jacket material: PVC
• Length: 50 m
• Colour: Beige
• Connectors: none (cable delivered without pre-terminated plugs)

How to use

Measure and cut the required length and strip the outer jacket carefully to avoid damaging the internal pairs and shielding. Terminate the cable on-site using appropriate RJ45 connectors or punch-down modules designed for solid AWG24 conductors, following the T568A or T568B wiring standard as required. Ensure the shielding is properly grounded when connecting to shielded connectors, panels or housings to maintain the SF/UTP performance.

Recommendations

Install the cable away from power lines and high-interference equipment where possible. Use the cable for fixed in-wall or conduit runs rather than frequent flexing or patch cord applications, and verify continuity and performance with a cable tester after termination to confirm correct pairing and shielding integrity.