Kuitu-lähetin-vastaanotinmoduuli BlueOptics 2779120000-BO 10000 Mbit/s SFP+

The BlueOptics 2779120000-BO 10000 Mbit/s SFP+ is a compact fiber optic transceiver module designed for high-speed network connections. With an SFP+ interface and a rated maximum data transfer rate of 10 Gbit/s, this silver-coloured module is intended for use in switches, routers and network interface cards that support SFP+ ports. The module's small form factor and light weight (approximately 20 g) make it suitable for dense installations where space and port density are important. The manufacturer specifies a mean time between failures (MTBF) of 1,000,000 hours, indicating reliability appropriate for continuous network operation.

Advantages

This SFP+ transceiver supports 10 Gbit/s links over fiber, offering a standardized SFP+ interface for broad compatibility with equipment that accepts hot-pluggable optical modules. The module's compact and lightweight design facilitates installation in high-density racks without significant added weight, while the silver finish provides a neutral visual match to most networking hardware. A high MTBF rating reflects expected long-term operation under typical network conditions.

Suitable for

• 10 Gbit/s fiber uplinks between switches and routers
• Server connections to optical ports on network adapters
• Data center optical interconnects requiring SFP+ modules
• Upgrading existing SFP+ capable equipment to 10 Gbit/s links

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Product colour: Silver
• Weight: 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours

How to use

Install the BlueOptics SFP+ module into a compatible SFP+ port on your switch, router, or network interface card until it clicks into place; the module is hot-pluggable so it can be inserted or removed while equipment is powered on if the host device supports hot-swap. Connect an appropriate single-mode or multimode fiber optic cable with the matching connector type to the transceiver's optical interface. Configure the host equipment's port settings (speed, duplex, and any required link parameters) according to the network design and verify link status through the device management interface.

Recommendations

Handle the transceiver by its housing and avoid touching the optical interface. Keep dust caps on unused ports and clean fiber connectors before insertion. Verify compatibility with the host device and use fiber cabling that meets the link distance and performance requirements for 10 Gbit/s operation.