Kuitu-lähetin-vastaanotinmoduuli BlueOptics LSP441-BO SFP+ 300 m

The BlueOptics LSP441-BO SFP+ 300m is a fiber optic transceiver module designed for 10GBASE-SR short-range multimode links. Housed in an aluminium casing and weighing approximately 20 grams, the module provides optical transmission and reception at 850 nm via an LC duplex connector and complies with MSA form-factor and electrical interface conventions for SFP+ ports. It is intended for deployment in switches, routers, storage systems and other network devices that accept SFP+ transceivers and support 10 Gbit/s multimode operation up to 300 metres.

Advantages

The module supports 10 Gbit/s data rates over multimode fiber and uses standard LC duplex connectors for bidirectional optical signalling. Its compact SFP+ form factor and aluminium housing combine low weight with mechanical durability for rack-mounted and modular network equipment. Built and tested to MSA-compatible specifications, the transceiver includes digital diagnostics monitoring (DDM/DOM) support where the host hardware provides the required interface, enabling remote monitoring of supply voltage, laser currents, optical power and temperature. The design focuses on compatibility with common network platforms and predictable operational lifetime.

Suitable for

Key specifications

How to use

Install the BlueOptics LSP441-BO into an available SFP+ slot on the network device following the device manufacturer's hot-swap or insertion guidelines. Connect an appropriate LC duplex multimode patch cable between the transceiver and the corresponding port on the remote transceiver or patch panel. Ensure the host device firmware or driver recognises MSA-compatible SFP+ modules and, if needed, enable or verify DDM/DOM access in the system management interface to monitor operating parameters. Observe standard ESD precautions during handling and avoid touching the optical interface; keep protective caps on the connector when not in use.

Recommendations

Use OM3/OM4 multimode fibre for optimal reach and performance at 10 Gbit/s, and verify link budgeting and connector cleanliness before commissioning. Confirm that the target hardware supports DDM/DOM if remote diagnostics are required, and choose high-quality fibre patch cords and connectors to maintain low insertion loss and consistent performance.