Kuitulähetin-vastaanotinmoduuli BlueOptics 407-BBZU-BO QSFP MTP/MPO

The BlueOptics 407-BBZU-BO QSFP MTP/MPO fiber optic transceiver module is a 40G multimode solution designed for high-speed networking. Featuring a QSFP interface and an MTP/MPO connector, the module is housed in an aluminium body and weighs approximately 20 g. It supports optical transmission over multimode fiber and is intended for use where reliable 40 Gbit/s connectivity and compact transceiver form factor are required.

Advantages

This QSFP transceiver offers a compact aluminium construction and a lightweight design that simplify installation and handling in dense network environments. The MTP/MPO connector supports multi-fiber connections for parallel optics applications, enabling simultaneous transmit and receive channels. The module is built to industry MSA-compatible form factors and is suitable for integration into systems that accept QSFP modules.

Suitable for

• High-speed Ethernet links up to 40 Gbit/s over multimode fiber
• Data center switch uplinks and spine connections
• Short-reach optical interconnects between networking devices
• Environments requiring MTP/MPO parallel-fiber connections

Key specifications

• Interface type: QSFP
• Connector type: MTP/MPO (multi-fiber parallel connector)
• Housing material: aluminium
• Weight: approx. 0.02 kg
• Optical fiber type: multimode fiber (MMF)
• Nominal data rate: 40 Gbit/s

How to use

Insert the transceiver into a compatible QSFP slot on the networking device until it latches into place. Connect an MTP/MPO multi-fiber patch cord to the transceiver connector, ensuring proper orientation and secure coupling. Configure the host device for the intended 40 Gbit/s link and verify link status through the device management interface. Handle the transceiver by its body and avoid touching the optical interfaces; keep protective caps on the connector when not in use.

Recommendations

For optimal performance, use high-quality multimode fiber patch cords and maintain clean connector end faces. Confirm that the host hardware supports QSFP modules and the required 40 Gbit/s protocol. If available, enable Digital Diagnostics (DDM/DOM) on the host device to monitor module parameters and assist with troubleshooting.