Lanview MO-G-SFP-10G-SR verkon lähetin-vastaanotinmoduuli kuitu 10000 Mbit/s SFP+ 850 nm

Lanview SFP-10G-SR is a compatible SFP+ optical transceiver module designed for 10 Gigabit Ethernet short-range fiber connections. The module fits standard SFP+ slots and supports multimode fiber links for distances typically used in server rooms, data centers and campus networks. It provides hot-pluggable installation and a compact SFP+ form factor for straightforward replacement or upgrade of existing network equipment.

Advantages

The transceiver supports 10 Gbps data rates over multimode fiber and conforms to SFP+ mechanical dimensions for compatibility with a wide range of switches, routers and network interface cards. Hot-pluggable design minimizes downtime during installation or replacement. The module is built to enable reliable short-range connectivity in dense networking environments while maintaining low power consumption and a small physical footprint.

Suitable for

• 10 Gigabit Ethernet links within data centers and server rooms
• Short-range fiber connections on campus networks
• Upgrading or replacing SFP+ ports in switches, routers and NICs
• High-speed interconnects between racks and network aggregation points

Key specifications

• Interface: SFP+ form factor, compatible with SFP+ ports
• Data rate: 10 Gbps
• Fiber type: Multimode fiber
• Typical operating range: short-range multimode links
• Optical wavelength: short-range multimode wavelength (850 nm class)
• Installation: Hot-pluggable
• Power consumption: low-profile SFP+ module power envelope

How to use

Insert the Lanview SFP-10G-SR into an available SFP+ slot on a switch, router or network interface card until it clicks into place. Connect the multimode fiber patch cable to the transceiver’s optical connector, ensuring correct polarity and secure connections at both ends. After installation, verify link status and speed on the network device; the module supports automatic negotiation to establish a 10 Gbps link where supported. To remove the module, disconnect the fiber cable and release the transceiver following the host device’s recommended procedure.

Recommendations

Use compatible multimode fiber cabling and follow equipment vendor guidelines for SFP+ compatibility to ensure optimal performance. Maintain clean fiber connectors and perform regular inspections to prevent signal loss. Handle the module carefully and observe ESD precautions during installation.