Liiketunnistin Steinel IS 3360-R COM1 AP IP54 360° tunnistus

The Steinel IS 3360-R COM1 AP IP54 360° detection motion sensor is a wall- or ceiling-mounted presence and movement detector designed for indoor and sheltered outdoor environments. With full 360-degree coverage and IP54 protection, it reliably detects occupants and movement across a broad area to control lighting and other automation systems. The compact housing supports surface mounting and is suitable for residential corridors, stairwells, entrances and covered exterior areas where weather resistance is required.

Advantages

This Steinel motion sensor offers comprehensive rotational detection that minimises blind spots and simplifies sensor placement. Its IP54 rating provides protection against dust ingress and splashing water, enabling use in sheltered outdoor locations. The device combines reliable presence detection with adjustable settings for sensitivity and time delay, allowing efficient energy management and automatic control of lighting and connected systems. The surface-mounted design facilitates installation on walls or ceilings without recessed mounting.

Suitable for

• Corridors and staircases in residential and commercial buildings
• Entrance areas and lobbies
• Covered outdoor walkways, porches and carports
• Utility rooms, storage areas and garages with intermittent occupancy

Key specifications

• Detection angle: 360° coverage
• Protection class: IP54 (dust protected, splash-resistant)
• Mounting: surface mount on wall or ceiling
• Detection type: presence and movement detection
• Adjustable settings: sensitivity and time delay controls
• Typical application areas: indoor and sheltered outdoor locations

How to use

Mount the sensor on a stable wall or ceiling surface at the recommended height to achieve the intended detection area; avoid pointing the sensor directly at heat sources or large glass surfaces that can cause false triggers. Connect the device to the lighting or control circuit following local electrical regulations and the manufacturer’s wiring instructions. After powering the unit, adjust sensitivity and time delay settings to match occupancy patterns and desired switch-off behaviour. Test the coverage by walking through the detection area and fine-tune the sensor orientation and settings if necessary.

Recommendations

For reliable operation, keep the sensor lens clear of obstructions and perform periodic functional checks. In exposed locations choose a sheltered mounting position to maintain IP54 protection; do not expose the sensor to direct weather conditions beyond splash and dust. Use sensitivity and time delay adjustments to balance energy savings and occupant comfort.