Verkon lähetin-vastaanotinmoduuli BlueOptics BO25K13640D-BO 40 Mbit/s QSFP 1310 nm

The BlueOptics BO25K13640D-BO is a network transceiver module engineered for data links requiring a QSFP interface and single-wavelength transmission at 1310 nm. Rated for a maximum data transfer rate of 40 Mbit/s, this compact optical module uses an LC fibre connector and comes in a lightweight metal/plastic housing with grey and red colouring. The module is intended for use in compatible switches, routers and media converters that accept QSFP transceiver form factors and provides a standardized optical interface for short- to medium-distance links.

Advantages

The transceiver delivers a defined 1310 nm optical wavelength with an LC connector, offering predictable signal characteristics for network planning. Its QSFP interface provides a common mechanical and electrical connection for equipment that supports QSFP modules. With a low weight of approximately 40 g and compact dimensions, the unit is easy to install and replace in rack-mounted or modular networking hardware. The simple specification and standard connector type support interoperability across devices that adhere to QSFP and LC optical standards.

Suitable for

• Establishing optical links between switches and routers that accept QSFP transceivers
• Short- to medium-distance fibre connections using 1310 nm wavelength
• Network upgrades where a 40 Mbit/s optical segment is required
• Replacement of existing QSFP optical modules with LC connector interfaces

Key specifications

• Interface type: QSFP
• Maximum data transfer rate: 40 Mbit/s
• Optical wavelength: 1310 nm
• Connector type: LC fibre connector
• Weight: 0.04 kg
• Product colour: Grey and Red

How to use

Confirm compatibility of the BlueOptics BO25K13640D-BO with the host device by checking the device documentation for supported QSFP modules and optical wavelengths. Power down or follow hot-swap procedures recommended by the equipment manufacturer before inserting the transceiver into the QSFP slot. Align and insert the module until it seats securely; connect the LC-terminated fibre patch cable to the module’s LC port. After installation, verify link status and configure any required interface settings on the host device to match the 40 Mbit/s link speed and optical parameters.

Recommendations

Store and handle the transceiver in a clean, dry environment and avoid touching the optical connector endfaces. Use dust caps on the LC connector when the module is not connected, and follow ESD precautions when handling the unit. For reliable operation, ensure the connected fibre and patch cords are rated for 1310 nm transmission and that the host equipment supports the module’s QSFP form factor and 40 Mbit/s link speed.