SFP-lähetin-vastaanotinmoduuli BlueOptics SFP-10G-SR-AR-LEG-BO 10000 Mbit/s 850 nm

The BlueOptics SFP-10G-SR-AR-LEG-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s short-range data transmission over multimode fiber. It operates at an 850 nm wavelength, features an SFP+ interface and a duplex LC connector, and is RoHS compliant. The module is compact and lightweight (approx. 20 g), intended for installation in network switches, routers, storage systems and other compatible networking equipment that support MSA-compliant SFP+ transceivers.

Advantages

The transceiver supports a 10,000 Mbit/s maximum data rate and an 850 nm wavelength suitable for multimode fiber short-reach links. Manufactured according to MSA standards, it is compatible with a wide range of hardware that accepts SFP+ 10GBASE-SR modules. Its silver housing and compact SFP+ form factor simplify installation and replacement. The module’s construction and testing procedures are aimed at stable operation and interoperability in mixed-vendor environments.

Suitable for

• 10 Gbit/s short-reach connections over multimode fiber
• Interconnects between switches, routers and servers with SFP+ ports
• Data center and campus aggregation links up to short distances
• Upgrades or replacements for MSA-compliant 10GBASE-SR SFP+ ports

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Wavelength: 850 nm
• Connector: LC duplex (multimode fiber)
• RoHS compliance
• Weight: 0.02 kg
• Product colour: Silver

How to use

Insert the SFP-10G-SR-AR-LEG-BO transceiver into a compatible SFP+ port on your network device until it clicks into place, then connect LC duplex multimode fiber patch cords to the module’s ports, observing correct transmit/receive orientation. After physical installation, verify link status and negotiate speed on the host device per its configuration interface. Ensure the host device firmware or software supports third-party MSA-compliant SFP+ modules and, if required, enable any diagnostics or monitoring features provided by the hardware.

Recommendations

Use high-quality multimode fiber (OM3/OM4 where applicable) and suitable patch cords to achieve optimal short-reach performance. Confirm that the receiving equipment supports 10GBASE-SR operation over 850 nm and check for Digital Diagnostic Monitoring (DDM/DOM) support if remote monitoring is needed. Follow ESD precautions during handling and avoid bending fibers beyond recommended radii to maintain signal integrity.